HP Visualize J5000 hp Visualize J5000, J7000 workstations owner's guide (a4476 - Page 226

Booting Your Workstation Usually, you start your workstation by turning it on and waiting for HP-UX to boot automatically. However, you may not always want the usual sequence to occur. For example, you may want to start your workstation from an operating system that is stored on a device that is different from your usual boot device. If your normal operating system kernel or the disk on which it resides becomes damaged or unusable, you may wish to boot from a different disk or perhaps another type of device, such as a DDS-format tape drive. Here are some situations and examples: • If you know which device you want to boot from, and you know that it contains a bootable operating system, follow the directions in "Accessing the Boot Console Interface" earlier in this appendix, and then type the following at the prompt: Main Menu: Enter a command or a menu > boot device Enter where device is the hardware path to the device, specified in Mnemonic Style Notation (see Table D-2). For example, if you wish to boot an operating system that is stored on a DDS-format tape in a drive that is located at ''scsi.1.0'', follow the directions in "Accessing the Boot Console Interface" earlier in this appendix, and then type the following command at the prompt: Main Menu: Enter a command or a menu > boot scsi.1.0 Enter The operating system on the specified device is used to start your workstation. D-9