HP Visualize J5000 hp Visualize J5000, J7000 workstations owner's guide (a4476 - Page 213
The C1700A Magneto-Optical Autochanger
View all HP Visualize J5000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 213 highlights
6. Write in the type of external single-ended drives currently con- nected to your workstation under the heading "External Device Drives" and each drive's SCSI device ID under the heading "Device ID Number." 7. Add your new drive to the table if it is an external device. If it is an internal drive, continue to Step 8. NOTICE: The C1700A Magneto-Optical Autochanger uses three SCSI IDs, and accounts for three of the seven devices allowed on the SCSI bus. 8. Check to see which SCSI device IDs are not used. You may use ID numbers 0 through 6 if they are not already in use. If the default ID on your drive does not conflict with any existing drive IDs, use that ID. If your default address conflicts with an existing drive ID, you need to assign a new SCSI device ID to your drive. Refer to the drive's installation documentation for information on changing the device ID. CAUTION: Do not use SCSI device ID 7 for any device. It is reserved for the built-in SCSI bus controller. C-19