HP Visualize J5000 hp Visualize J5000, J7000 workstations owner's guide (a4476 - Page 43
SCSI ID and Device File Information for HP-UX 9.05, SCSI ID and Device File Information for HP-UX 10
View all HP Visualize J5000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
SCSI ID and Device File Information for HP-UX 9.05 Default device file names for your drives are listed below. The underlined number in the device file name indicates the SCSI ID number: Device CD-ROM drive DDS-format tape drive Floppy disk drive Device File Name /dev/dsk/c201d2s0 /dev/rmt/3m /dev/rfloppy/c201d0s0 These device file names assume the SCSI ID of your drive is set to the factory default. If you change the factory-set value, you must create a new device file and substitute the pathname of your device file for the pathname above. See the System Administration Tasks manual for information on how to create a device file. SCSI ID and Device File Information for HP-UX 10.0 or Later Default device file names for your drives are listed below. Device CD-ROM drive Floppy disk drive Device File Name /dev/[r]dsk/c#t#d# /dev/rfloppy/c#t#d# where c# identifies the bus address of the SCSI interface card t# identifies the target address of the SCSI disk d# identifies the SCSI lun address (0, except for disk arrays) Device file names for DDS drives at HP-UX 10.0 or later depend on the naming conventions of the system on which you are installing: For installation on a system permitting long file names /dev/rmt/c#t#d#BEST AT&T style, best available density, character entry, rw-rw-rw /dev/rmt/c#t#d#BESTb Berkeley style, best available density character entry, rw-rw-rw /dev/rmt/c#t#d#BESTn AT&T style, no rewind, best available density, character entry, rw-rw-rw /dev/rmt/c#t#d#BESTnb Berkeley style, no rewind, best available density, character entry, rw-rw-rw 1-25