HP Visualize J5000 hp Visualize J5000, J7000 workstations owner's guide (a4476 - Page 48
nected to your workstation, has paper loaded
View all HP Visualize J5000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
This chapter describes how to configure your workstation to use a printer that you have physically attached to either the parallel connector or the serial (RS-232C) connector on the rear of your workstation. The instructions in this chapter assume you are using the HP-UX version 9.05 or later operating system with the HP VUE version 3.0 interface. NOTICES: Make sure you have installed the printer as described in the manufacturer's instructions before following the instructions in this chapter. Also ensure that the printer is powered on, connected to your workstation, has paper loaded, and is online. Some procedures in this chapter require you to log in as root. If you cannot log in as root, contact your system administrator. 2-2
2-2
This chapter describes how to configure your workstation to use a
printer that you have physically attached to either the parallel connec-
tor or the serial (RS-232C) connector on the rear of your workstation.
The instructions in this chapter assume you are using the HP-UX
version 9.05 or later operating system with the HP VUE version 3.0
interface.
NOTICES:
Make sure you have installed the printer as
described in the manufacturer’s instructions
before following the instructions in this chapter.
Also ensure that the printer is powered on, con-
nected to your workstation, has paper loaded,
and is online.
Some procedures in this chapter require you to
log in as
root
. If you cannot log in as
root
, con-
tact your system administrator.