Kyocera KM-3035 3035/4035/5035 Operation Guide Rev-6.0 - Page 109
screen in step 1., Selecting how to finished up the copy sets
View all Kyocera KM-3035 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 109 highlights
3 Selecting between 1-sided or 2-sided copies This procedure selects the type of finished copies to be made between 1-sided and 2-sided. 1 With the content of the "Basic" tab displayed, touch the "1 sided/2 sided" key. The "1 sided/2 sided" screen will be displayed. Inch specifications Ready to Job build. Place originals then press Start key. Job Build - Step1 11x81/2" Select paper Offset Finished Basic 1 sided Original type AMS Reduce /Enlarge Quality 1 sided copy 1 sided/ 2 sided Back Edge Orig. set direction Edit 1 sided copy-Left Finished page #:0 Set End Insert page Metric specifications Ready to Job build. Set original. Press Start key. Job Build-Step 1 Select paper Group Finished Basic 1-sided Original type AMS Reduce/ Enlarge Quality 1-sided Copy 1-sided/ 2-sided Back Edge Orig. set direction Edit 1-sided Copy-Left Finished page #: 0 Set End Insert blank page NOTE The setting in regard to making either 1-sided or 2-sided copies can only be made in the first step of the job build mode and will apply to all steps in the copy job. 2 Touch the "1 sided" key or the "2 sided" key, as appropriate, and then select the binding direction you want for the finished copies. Follow the instructions on the right side of the touch panel and verify the direction in which the originals were set. Inch specifications Ready to Job build. Place originals then press Start key. 1 sided/ 2 sided copy Finished 1 sided copy 2 sided copy Open from left Open from right Open from top Set Back Close Check direction Check direction of original top side. Rear Left top corner Metric specifications Ready to Job build. Set original. Press Start key. 1-sided / 2-sided Copy Finished 1-sided Copy 2-sided Copy Left binding Right binding Top binding Set Back Check direction Check direction of original. Close Back Edge Left top corner Section 5 OTHER CONVENIENT FUNCTIONS 3 Touch the "Close" key. The touch panel will return to the screen in step 1. 4 Selecting how to finished up the copy sets If the optional Document Finisher is installed on your copier, this procedure lets you select whether to staple or hole punch the finished copy sets. 1 With the content of the "Basic" tab displayed, touch the "Finished" key. The "Finished" screen will be displayed. Inch specifications Ready to Job build. Place originals then press Start key. Job Build - Step1 11x81/2" Select paper Offset Finished Basic 1 sided Original type AMS Reduce /Enlarge Quality 1 sided copy 1 sided/ 2 sided Back Edge Orig. set direction Edit 1 sided copy-Left Finished page #:0 Set End Insert page Metric specifications Ready to Job build. Set original. Press Start key. Job Build-Step 1 Select paper Group Finished Basic 1-sided Original type AMS Reduce/ Enlarge Quality 1-sided Copy 1-sided/ 2-sided Back Edge Orig. set direction Edit 1-sided Copy-Left Finished page #: 0 Set End Insert blank page NOTE The setting in regard to how the copy sets will be finished can only be made in the first step of the job build mode and will apply to all steps in the copy job. IMPORTANT! If the designation for the direction that the originals are set is not correct, copying may be accomplished incorrectly. 5-63