Kyocera KM-3035 3035/4035/5035 Operation Guide Rev-6.0 - Page 261
TROUBLESHOOTING, 1. If one of the following messages is displayed
View all Kyocera KM-3035 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 261 highlights
Section 9 TROUBLESHOOTING 1. If one of the following messages is displayed When any of the following messages appears on the message display, take the indicated action. Message Procedure "Close xxx cover x." The cover indicated is open. Close the cover securely. Reference page -- "Add paper in drawer." ["Add paper in cassette."] "Set drawer. " ["Close paper cassette."] There is no paper in the drawer[cassette] indicated. Load paper. 3-1 One of the drawers[cassettes] is not closed properly. Pull it out and push it back in all the way. -- "Paper drawer is out of order. Select another paper drawer." ["Paper cassette is out of order. Select other paper cassette. "] The drawer[cassette] currently in use is out of order and cannot be used. Contact your service representative immediately. Continue copying using another drawer[cassette]. -- "Check paper size." No paper that can be used in the selected mode is loaded. Check the paper. -- "Reposition original." The orientation of the original and the selected paper are different. Change the orientation of the original. If the [Start] key is pressed, same-size copying will be performed. "Exceeds pre registered copying quantity." ["Copy limit for this ID-code has been reached. No copying possible."] The number of copies reached the limit set in the copy management mode and no more copies can be made. Clear the copy count from the management mode. "Ready to copy. Add toner." There is not enough toner in the copier. Replace the toner container immediately as only one copy can be made at a time. "Add toner to resume copying." There is not enough toner in the copier to make copies. Replace the toner container immediately. "System error. Main switch off/on." A system error has occurred. Turn the main power switch OFF and then ON. "System error. Disconnect power plug from the socket." A system error has occurred. Disconnect the power plug from the outlet and connect it again. -- 7-1 10-3 10-3 -- -- * If the optional Fax Kit is installed in your copier, when the power cord is unplugged from the outlet, original data or reserved communication information stored in the memory may be lost. 9-1