Kyocera KM-3035 3035/4035/5035 Operation Guide Rev-6.0 - Page 250
How to set originals in the Document Processor, How to set originals on the platen
View all Kyocera KM-3035 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 250 highlights
Section 8 OPTIONAL EQUIPMENT 4 How to set originals in the Document Processor 1 Adjust the original insertion guides to the original size. IMPORTANT! Do not set originals exceeding the limit indicated on the sticker attached on the rear original insertion guide. Setting more originals than specified may cause original misfeed. NOTE Before setting the originals in the Document Processor, check that no original from the previous operation is remaining on the original eject cover. Originals remaining on the original eject cover may cause original misfeed. 5 How to set originals on the platen When using an original that cannot be set in the Document Processor, such as a book or magazine, open the Document Processor and place it on the platen. 1 Hold the Document Processor open/close handle and open the Document Processor. * Before opening the Document Processor, check that no original is present on the original table or original eject cover. If present, the original may fall off when the Document Processor is opened. 2 Set the originals on the original table in correct sequence with the side to be copied facing upward. Securely insert the leading edge of the originals into the Document Processor as far as they will go. 2 Set the original with the side to be copied facing downward. Be sure to align the original with the original size scales. * When setting large size paper such as 8 1/2" x 11", A4R or larger, pull out the support extension. 8-2