Kyocera KM-3035 3035/4035/5035 Operation Guide Rev-6.0 - Page 262

Section 9 TROUBLESHOOTING Message "Call service." Procedure Reference page Open and close the front cover. If the same message appears again, make a note of the "C" and the number appearing with it, turn the main power switch OFF (O), unplug the power cord from the outlet, and contact your service representative or authorized service center. -- "Time for maintenance." Periodic maintenance is necessary to keep your copier in good condition. Contact your service representative or an authorized service center as soon as possible. -- "Close Document processor cover." The Document Processor original cover of the optional document processor is open. Close the cover securely. -- "Memory full." The copier memory is full. Either print out or clear all scanned data. It is not possible to copy or scan another original until one of these two operations is performed. The copier memory size and the capacity for scanning originals are shown below. Number of originals that can be scanned* Standard memory (64MB): approximately 322 pages When the optional Hard Disk is installed (20GB): approximately 70,000 pages** * When using our standard original (A4 original, 6% text) ** The maximum number of originals that can be scanned at one time is 999 (11" x 8 1/2" [A4]). -- "Paper misfeed." "Paper misfeed. Careful for Drum." If paper is misfed, the copier will stop and the location of the misfeed will appear on 9-4 the message display. Remove the misfed paper with the main power switch turned ON ( | ) by following the appropriate procedure. If "Careful for Drum." is displayed, be sure not to touch the drum area that is located inside the machine when removing the jammed paper. "Duplex tray inoperable, call service." ["Duplex unit is out of order. Call service."] The duplex unit is out of order and duplex copying is not possible. Contact your service representative immediately. -- "Clean the slit glass for original fed from DP." ["Clean the slit glass for original fed."] The slit glass is dirty. This may result in black lines or other blemishes appearing on copies when you use the optional Document Processor, so you should perform the cleaning operation on the slit glass. 10-1 "Attach Finisher." Connect the optional Document Finisher securely to the copier. -- "Finisher is out of order. Detach Finisher." The optional Document Finisher is out of order and cannot be used for the moment. Contact your service representative or an authorized service center as soon as possible. -- "Paper capacity exceeded. Remove paper from Finisher." The maximum number of sheets that can be stored on the optional Document Finisher has been exceeded. Remove the copies from the Document Finisher. -- "Remove paper form inner tray of Finisher." Paper has been misfed inside the optional Document Finisher. See the Document Finisher's Operation Guide and remove the paper. 9-2