Kyocera KM-3035 3035/4035/5035 Operation Guide Rev-6.0 - Page 31
(3) Loading paper into the multi-bypass tray, IMPORTANT
View all Kyocera KM-3035 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
5 Set the supplied paper size sheet so that the size of the paper loaded can be checked by looking at the front of the drawer[cassette]. Section 3 PREPARATIONS 1 Open the multi-bypass tray. 6 Gently push the drawer[cassette] back in. NOTE Before leaving the copier in disuse for a prolonged period of time, remove the paper from the drawer(s)[cassette(s)] and seal it in its original packaging to protect from moisture. Also, when storing paper in a high temperature and high humidity environment, seal it in a moisture-proof bag. 2 Adjust the insert guides to the size of the paper to be loaded. (3) Loading paper into the multi-bypass tray Up to 200 sheets of standard copy paper (75 g/m2 - 80 g/m2), of a size between 11" x 17" [A3] and 5 1/2" x 8 1/2" [A6R] can be set on the multi-bypass tray at one time. When copying onto special paper, be sure to use the multi-bypass tray. NOTE The types of special paper and the number of sheets that can be loaded in the multi-bypass tray are: • Transparencies: 25 sheets • Standard paper (120 g/m2): 130 sheets • Standard paper (160 g/m2): 100 sheets 3 Insert the paper along the guides as far as it will go. IMPORTANT! • When copying onto OHP transparencies, be sure to fan through them a few times to separate the sheets before setting them on the multi-bypass tray. • When copying onto non-standard size paper, perform the procedure in "(1) Paper size and type" on page 7-87 and select the paper size. • When setting special paper such as OHP transparencies and thick paper on the multi-bypass tray, the type of paper must be specified under "(1) Paper size and type" on page 7-87. • You can select to have the "Bypass setting" screen (see page 7-86) displayed whenever the "Bypass" key is touched. (See "Multi-bypass tray setting display ON/OFF" on page 7-45.) IMPORTANT! • When you are setting paper onto the multi-bypass tray, make sure that the side facing upward when the package is opened is the side that is facing upward on the multi-bypass tray as well. In addition, if the leading edge of the paper is curled at all, straighten it out before setting it on the multi-bypass tray. • ALWAYS straighten out curled paper before setting it on the multibypass tray. 3-3