Kyocera KM-3035 3035/4035/5035 Operation Guide Rev-6.0 - Page 273
If other trouble occurs, Trouble, Checkpoint, Procedure, Reference - service manual
View all Kyocera KM-3035 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 273 highlights
Section 9 TROUBLESHOOTING 4. If other trouble occurs If trouble occurs with your copier, carry out the applicable checkpoints and procedures indicated on the following pages. If the trouble persists, contact your service representative or authorized service center. Trouble Checkpoint Nothing lights on the operation panel when the main power switch is turned ON. Is the power plug connected to an AC outlet? Procedure Connect the plug to an AC outlet. Reference page -- No copies come out when the [Start] key is pressed. Is there any message appearing on the message display? Copies come out blank. Are the originals set correctly? Perform the corrective action corresponding 9-1 to the message. - When setting originals on the platen, place 4-1 them face-down. When setting originals in the optional 8-2 Document Processor, place them face-up. Copies come out too light. Is the copier in the auto exposure mode? To change the overall exposure, perform the auto exposure adjustment. 7-73 Is the copier in the manual exposure mode? Adjust the exposure to the correct degree 4-2 using the copy exposure adjustment keys. To change the overall exposure, perform the exposure adjustment for the each copy quality mode. 7-75 7-76 7-77 Is the add toner message displayed? Replace the toner container. 10-3 Is paper wet? Replace the paper with new paper. 3-1 9-13