Kyocera KM-3035 3035/4035/5035 Operation Guide Rev-6.0 - Page 176
Default settings, Description, Available, settings, Factory, Reference
View all Kyocera KM-3035 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 176 highlights
Section 7 COPIER MANAGEMENT FUNCTIONS 2. Default settings The state that the copier enters at the end of warm-up or when the [Reset] key is pressed is called the "initial mode". The modes, functions and other settings that are automatically pre-set for the initial mode are called "default settings". These default settings are separated into two categories: "Copy defaults" and "Machine defaults" and can be changed as desired to suit your copying needs. (1) Machine default settings The following table indicates the machine default settings available in this copier. Change any or all of the settings as desired in order to make the most effective use of your copier. Default setting Description Available settings Factory setting Reference page Auto drawer[cassette] If the paper in one drawer[cassette] runs out during On / Off On switching ON/OFF copying, the automatic drawer[cassette] switching function will switch paper feed from the empty drawer[cassette] to another drawer[cassette] that contains the same size of paper in the same orientation for uninterrupted copying. To enable this function, it is necessary to turn the related setting "On". 7-42 In order to prevent a drawer[cassette] that holds a different type of paper from being switched to when the automatic drawer[cassette] switching function is turned ON, it is necessary to select "Feed same paper type" as well. All types of paper / Feed same paper type All types of paper Paper size (drawer[cassette] No.1 - No.4) Sets the size of paper that is loaded in drawers[cassettes] No.1 through No.4. If you want the size to be detected automatically, select "Auto Detection" (Automatic size detection). If you want to manually set the size of paper, select "Standard sizes". Auto Detection / Standard sizes Auto Detection 7-43 You can also select the desired unit of measurement: "Inch" or "Centimeter". Inch Centimeter Inch specification: Inch Metric specification: Centimeter You can then select the paper size. * The setting for drawer[cassette] No.3 and No.4 will only be available when the optional Paper Feeder is installed on your copier. A3 A4 A4R A5R B4 B5 B5R Folio 11 x 17 8 1/2 x 14 11 x 8 1/2 8 1/2 x 11 5 1/2 x 8 1/2 8 1/2 x 13 8K 16K - - - 7-38