Kyocera KM-3035 3035/4035/5035 Operation Guide Rev-6.0 - Page 30
(2) Loading paper into the drawer[cassette], 11 x 17, A5R, B5R, B5, A4R, A4, B4, A3, Folio
View all Kyocera KM-3035 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
Section 3 PREPARATIONS (2) Loading paper into the drawer[cassette] Up to 500 sheets of standard paper (75 or 80 g/m2/standard paper as specified by our company) or colored paper can be loaded into the each drawer[cassette]. The each drawer[cassette] can be set to hold paper of any desired size from 5 1/2" x 8 1/2", 8 1/2" x 11", 11" x 8 1/2", 8 1/2" x 13", 8 1/2" x 14", 11" x 17", A5R, B5R, B5, A4R, A4, B4, A3, Folio, 8K and 16K. 4 Set the paper flush against the left-hand wall of the drawer[cassette]. IMPORTANT! Set the type of paper (standard paper, recycled paper, etc.) to be loaded in the drawer[cassette] in "Paper type (drawer[cassette] No.1 No. 4)" on page 7-44. 1 Pull the drawer[cassette] out toward you as far as it will go. * Do not pull more than one drawer[cassette] out at a time. 2 Hold the width adjustment lever and move it to align the width guide with the required paper width. Paper sizes are marked inside the drawer[cassette]. IMPORTANT! • Make sure that there are no folds, etc., in the paper when it is set in a drawer[cassette]. Such paper may be the cause of paper jams. • There is a sticker (1 in the illustration) indicating paper capacity attached to the inside of the drawer[cassette]. Do not load paper above this limit. • When you are loading paper into a drawer[cassette], make sure that the side facing upward when the package is opened is the side that is facing upward in the drawer[cassette]. • Adjust the length adjustment plate and the width guide BEFORE loading paper into a drawer[cassette]. Failure to do so may result in skewed paper feed or a paper jam. • Make sure that the paper is set securely against the length adjustment plate and the width guide. If there is a gap between the paper and the adjustment plate or the width guide, readjust the plate and the guide to fit the paper snugly. 1 3 Hold the length adjustment plate and move it to align with the required paper length. 3-2