Kyocera KM-3035 3035/4035/5035 Operation Guide Rev-6.0 - Page 171
Response to exceeded restriction, starting with the current job when a department ID-code
View all Kyocera KM-3035 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 171 highlights
● Response to exceeded restriction Perform the following procedure to determine whether further use of the machine by the corresponding department will be discontinued immediately (starting with the current job) or with the next job, or if only an error message will be generated when a department ID-code has exceeded its set limit. NOTE If the optional Printer/Scanner Kit or Fax Kit is installed on your copier, even if you select here to have further use of the machine discontinued immediately (starting with the current job), if a department ID-code exceeds its set limit during scanning or during fax transmission, the actual restriction will start from the next job. 1 Select "Excess of limit Setting" under the "Setting item" column on the left side of the touch panel and then touch the "Change #" key. The "Excess of limit Setting" screen will be displayed. Inch specifications Managem. Def. Set. Close Setting item Scanner Managem. Fax Management Excess of limit Setting Def. Val. of coun. limit Total size 1 Total size 2 Total size 3 Value On On Unable to use 999999 81/2x11" No specif. 81/2x11" No specif. 81/2x11" No specif. Default setting - Management - Managem. Def set. Change # Metric specifications Managem. Def. Set. Close Setting item Scanner Managem. Fax Management Excess of limit Setting Def. Val. of coun. limit Total size 1 Total size 2 Total size 3 Value On On You cannot use 999999 A3 No specif. B4 No specif. A4 No specif. Default setting - Management - Managem. Def set. Change # Section 7 COPIER MANAGEMENT FUNCTIONS 2 To discontinue further use of the machine immediately (starting with the current job) when a department ID-code has exceeded its set limit, touch the "Stop job immediatly" key. To cancel further use of the machine starting from the next job, touch the "Stop after job done" key. To have an error message generated, touch the "Only warning" key. Inch specifications Excess of limit Setting Select proper setting when limit exceeded. Back Close Stop job immediatly Stop after job done Only warning Default setting - Management - Managem. Def set. Metric specifications Excess of limit Setting Select proper setting when limit exceeded. Back Close Stop job immediatly Stop after job done Only warning Default setting - Management - Managem. Def set. NOTE If you want to quit the displayed setting without changing it, touch the "Back" key. The touch panel will return to the screen in step 1. 3 Touch the "Close" key. The touch panel will return to the screen in step 1. 7-33