Kyocera KM-3035 3035/4035/5035 Operation Guide Rev-6.0 - Page 198
Changing the management code, Select Management code change [Change MGMT code
View all Kyocera KM-3035 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 198 highlights
Section 7 COPIER MANAGEMENT FUNCTIONS ● Changing the management code Perform the following procedure to change the management code used by the copy manager. IMPORTANT! If you change the management code from its factory default, be sure to keep some sort of record of the new management code. If, for any reason, you forget the registered management code, you will need to contact your service representative. 1 Display the "Machine default" screen. (See "(2) Accessing the machine default settings" on page 7-41.) Inch specifications Default setting / Counter Default setting Copy default Machine default Document Management Language Bypass setting Register orig. size Management BOX Management Print report End Counter check User Adjustment Metric specifications Default setting / Counter Default setting Copy default Machine default Document Management Language Bypass setting Register orig. size Management Hard Disk Management Print report End Counter check User Adjustment 2 Select "Management code change" ["Change MGMT code with #"] in the settings list on the left side of the touch panel and then touch the "Change #" key. The "Management code change" ["Change MGMT code with #"] screen will be displayed. Inch specifications Default setting / Counter Machine default Default menu Key sound ON/OFF Silent mode Date/Time Time difference Management code change Setting mode On On 2001/10/30 14:02 GMT+08:00 5000 Change # Close Up Down Metric specifications Default setting / Counter Machine default Default menu Key sound ON/OFF Silent mode Date/Time Time difference Management code change Setting mode On On 2001/10/30 14:02 GMT+08:00 5000 Change # Close Up Down 3 Use the keypad to enter a new 4-digit management code. Inch specifications Management code change Able to change management code.(# key) Back Close Default setting - Machine default Metric specifications Change MGMT code with # Able to change management code.(# key) Back Close Default setting - Machine default NOTE If you want to quit the displayed setting without changing it, touch the "Back" key. The touch panel will return to the screen in step 2. 4 Touch the "Close" key. The touch panel will return to the screen in step 2. 5 Touch the "Close" key once again. The touch panel will return to the "Default setting"screen. 6 Touch the "End" key. The touch panel will return to the contents of the "Basic" tab. 7-56