Sharp MX-M260 MX-M260 MX-M310 Operation Manual - Page 130

TROUBLESHOOTING AND MAINTENANCE MISFEED IN THE RSPF 1 Remove the misfed original. Check sections A, B, and C in the illustration at left A and remove the misfed original. B C Section A Document feeder cover Open the document feeder cover and carefully remove the misfed original from the document feeder tray. Close the document feeder cover. Section B Roller Open the RSPF and rotate the release roller in the direction of the arrow to feed the original out. Close the RSPF and then carefully remove the original. If the misfed original cannot be removed, open the document transport cover (below), and rotate the release roller again. If a small original (5-1/2" x 8-1/2", etc.) is misfed, or if an original misfeed occurs in the reversing tray of the RSPF, lift the document transport cover knob, open the document transport cover, and remove the original. Document transport cover Document transport cover knob 128 Section C Carefully remove the misfed original from the exit area. If the misfed original cannot be easily removed from the exit area, open the moveable part of the document feeder tray and remove the reversing tray, and then remove the original. Reversing tray Moveable part Note After removing a misfed original from the exit area, be sure to attach the reversing tray securely to the exit area (When the RSPF is installed.). 2 Open and close the RSPF to clear the misfeed message from the touch panel. The message can also be cleared by opening and closing the document feeder cover or the document transport cover. After the misfeed is removed and the misfeed message is cleared, a message will appear indicating the number of originals that must be reinserted in the RSPF. 3 Reinsert the originals that still must be scanned (Including the original that was being scanned when the misfeed occurred.), and press the [START] key( ). Copying of the remaining originals will resume.