Sharp MX-M260 MX-M260 MX-M310 Operation Manual - Page 135
Misfeed In The Upper Exit Area
View all Sharp MX-M260 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 135 highlights
TROUBLESHOOTING AND MAINTENANCE MISFEED IN THE UPPER EXIT AREA (when a job separator tray kit or finisher (MX-FN13) is installed) If a job separator tray kit or a finisher is installed, a misfeed may occur in the upper exit area. 1 Open the upper right side cover. 2 Gently pull the misfed paper out. Be careful not to tear the misfed paper during removal. 3 Close the upper right side cover. Make sure that the misfeed message is cleared. MISFEED IN AN OUTPUT TRAY (when a finisher (MX-FN13) is installed) 1 Open the front cover. 4 Slide the finisher back to the right. 2 While pressing the lever over to the left, slide the finisher to the left until it 5 Close the cover. stops. Gently slide the finisher 7 until it stops. 3 Turn roller rotating knob in the direction of the arrow to remove the misfed paper. 133