Sharp MX-M260 MX-M260 MX-M310 Operation Manual - Page 138
Removing staple jams
View all Sharp MX-M260 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 138 highlights
TROUBLESHOOTING AND MAINTENANCE Removing staple jams Follow the steps below to remove a staple jam. 1 Open the cover. 5 Lower the lever at the front end of the staple case. 2 While pressing the lever over to the left, slide the finisher to the left until it stops. Gently slide the finisher until it stops. 6 Replace the staple case. Push the staple case in until it clicks into place. 3 Lower the staple case release lever and remove the staple case. Pull the staple case out to the right. 7 Slide the finisher back to the right. Gently slide the finisher back to the right until it locks into its original position. 4 Raise the lever at the front end of the staple case and remove the jammed staple. Remove the leading staple if it is bent. If bent staples remain, a staple jam will occur again. 8 Close the cover. Gently slide the finisher back to the right until it locks into its original position. Caution Take care that a bent staple does not hurt you. 136