Sharp MX-M260 MX-M260 MX-M310 Operation Manual - Page 137
Staple Cartridge Replacement
View all Sharp MX-M260 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 137 highlights
STAPLE CARTRIDGE REPLACEMENT (when the finisher (MX-FN13) is installed) When the staple cartridge runs out of staples, a message will appear in the operation panel. Follow the procedure below to replace the staple cartridge. Replacing the staple cartridge 1 Open the cover. 5 Insert a new staple cartridge into the staple case as shown. Push the staple cartridge in until it clicks into place. 2 While pressing the lever over to the left, slide the finisher to the left until it stops. Gently slide the finisher until it stops. 6 Replace the staple case. Push the staple case in until it clicks into place. 3 Lower the staple case release lever and remove the staple case. Pull the staple case out to the right. 4 Remove the empty staple cartridge from the staple case. 7 Slide the finisher back to the right. Gently slide the finisher back to the right until it locks into its original position. 8 Close the cover. 7 Gently slide the finisher back to the right until it locks into its original position. Note Make a test print or copy in staple sort mode to verify that stapling takes place correctly. 135