Sharp MX-M850 MX-M850 MX-M950 MX-M1100 Operation Manual Suite - Page 65
Manual Finishing Mode
View all Sharp MX-M850 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 65 highlights
MANUAL FINISHING MODE When the inserter is installed, finishing operations such as stapling or punching can be performed without performing a copy or print operation. Touch the [MANUAL FINISHING] key to change modes. The following screen will appear. For information on manual finishing functions, see the following pages. (1) (2) Set the output function. Plain 8½x11 Plain 8½x11 Top Tray Offset Tray (3) (4) Staple (5) Saddle Stitch (6) Fold 2 Hole Punch (7) 3 Hole Punch (1) Inserter (upper tray), inserter (lower tray) key Use these keys to select the tray that you wish to use for finishing. Load the paper to be used for finishing and then select the tray on which the paper is loaded. (2) [Top Tray] key This sets the top tray as the output tray. (3) [Offset Tray] key This sets the offset tray as the output tray. (4) [Staple] key When selected, three keys appear to let you select the staple position. ☞ STAPLE FUNCTION / SADDLE STITCH FUNCTION (page 67) (5) [Saddle Stitch] key Use this to staple the output at the center and fold it into a booklet. ☞ STAPLE FUNCTION / SADDLE STITCH FUNCTION (page 67) (6) [Fold] key Use this to fold the output in half and then fold one side back. ☞ PAPER FOLDING FUNCTION (page 70) (7) [2 Hole Punch], [3 Hole Punch] key Use these to punch holes in output. ☞ PUNCH FUNCTION (page 69) • It may not be possible to use some functions, depending on the peripheral devices that have been installed. If the keys in your screen are not the same as in the above screen, check what devices have been installed. • While a finishing operation is being performed in manual finishing mode, it is not possible to switch to another mode. Similarly, it is not possible to switch to manual finishing mode during output in another mode. 65