Sharp MX-M850 MX-M850 MX-M950 MX-M1100 Operation Manual Suite - Page 87

PROBLEMS RELATED TO PAPER FEEDING AND OUTPUT Problem The original misfeeds (automatic document feeder). The paper misfeeds. Point to check Is too much paper loaded in document feeder tray? Is the original a long original? Is the original on thin paper? Is a torn piece of paper remaining in the machine? Is too much paper loaded in the tray? Are multiple sheets feeding at once? Solution Make sure that the stack of paper in the tray is not higher than the indicator line. ☞ PLACING ORIGINALS IN THE AUTOMATIC DOCUMENT FEEDER (page 53) When using the automatic document feeder to scan a long original, set the scan size to [Long Size]. (Note that long originals cannot be copied using the copy function.) Use the document glass to scan the original. If you need to use the automatic document feeder, use slow scan mode in the special modes to scan the original. Make sure all paper is removed. ☞ "3. REMOVING MISFEEDS" in the Maintenance Guide Make sure that the stack of paper in the tray is not higher than the indicator line. ☞ 2. LOADING PAPER (page 26) Fan the paper well before loading it. Are you using paper that is not within the specifications? Has the paper in the tray absorbed moisture? Are the bypass tray guides adjusted to the width of the paper? Is the bypass tray extension pulled out? Is the bypass feed roller dirty? Use SHARP-recommended paper. Using paper that is not supported may result in misfeeds, creases, or smudges. ☞ "SUPPLIES" in the Safety Guide * For paper that is prohibited or not recommended, see "USEABLE PAPER" (page 27). If you will not be using paper in a tray for a long time, remove the paper from the tray and store it in a bag in a dark and dry location. Adjust the bypass tray guides to the width of the paper. ☞ LOADING PAPER IN THE BYPASS TRAY (page 48) When loading a large size of paper, pull out the extension. ☞ LOADING PAPER IN THE BYPASS TRAY (page 48) Clean the surface of the bypass feed roller. ☞ "CLEANING THE BYPASS FEED ROLLER" in the Maintenance Guide 87