Sharp MX-M850 MX-M850 MX-M950 MX-M1100 Operation Manual Suite - Page 88

Problem The paper misfeeds. Paper does not feed from the paper tray. The image on paper is skewed. The automatic document feeder does not operate. Point to check Is 5-1/2" x 8-1/2" (A5) size paper loaded? Has the correct paper size been set? Did you add paper to the bypass tray? Is the paper loaded correctly in the paper tray? In the Paper Tray Settings of the system settings, are restrictions placed on the trays that can be used in each mode (copy, print, fax, Internet fax, and document filing)? Is too much paper loaded in the bypass tray? Are the bypass tray guides adjusted to the width of the paper? Are the original guides adjusted to the width of the paper? Have functions been disabled by the administrator? Solution Load 5-1/2" x 8-1/2" (A5) size paper in tray 4 (the second tray) or in the bypass tray. For the paper trays in which A5 size paper can be loaded, see "PAPER TRAY SETTINGS" (page 77). * When loading 5-1/2" x 8-1/2" (A5) size paper, place the paper in the horizontal (5-1/2" x 8-1/2"R (A5R)) orientation. If you are using a special size, be sure to specify the paper size. If the size of paper loaded in a tray was changed, be sure to check the paper size setting. ☞ PAPER TRAY SETTINGS (page 77) When adding paper, remove any paper remaining in the bypass tray, combine it with the paper to be added, and reload as a single stack. If paper is added without removing the remaining paper, a misfeed may result. ☞ LOADING PAPER IN THE BYPASS TRAY (page 48) Set the guides to the size of the paper. Make sure the height of the paper does not exceed the indicator line. ☞ 2. LOADING PAPER (page 26) Check the Paper Tray Settings and see if checkmarks appear in the checkboxes of each mode (Feeding Approved Job). Functions without a checkmark cannot be used for printing using that tray. ☞ PAPER TRAY SETTINGS (page 77) Do not load more than the maximum number of sheets. The maximum number of sheets varies depending on the paper type setting. For more information, see the specifications in the Safety Guide. Adjust the bypass tray guides to the width of the paper. ☞ LOADING PAPER IN THE BYPASS TRAY (page 48) Adjust the original guides to the width of the paper. ☞ PLACING ORIGINALS IN THE AUTOMATIC DOCUMENT FEEDER (page 53) Some functions may have been disabled in the system settings (administrator). Check with your administrator. 88