Brother International PR1055X Operation Manual - Page 109

Select whether or not to display the needle drop point Each touch of this key changes the brightness of the camera image. Rotate the pattern so that it is aligned with the chalk e reference lines, and then touch to display the embroidering screen. ADVANCED EMBROIDERY 1 When embroidering the edge pattern If the fabric has just been rehooped, use the move pattern keys to align the start point on the screen with the end point of the previous pattern, and then touch . Then, rotate the pattern to align the corner with the reference line, and then touch . 1 1 The screen where the pattern can be moved appears again. Touch to unlock the machine, and then f press the "Start/Stop" button to embroider the first pattern. When embroidering is finished and the following g message appears, touch . 2 When embroidering the pattern immediately before a corner If the fabric has just been rehooped, use the move pattern keys to align the start point on the screen with the end point of the previous pattern, and then touch . Then, align the point of the pattern (inner corner of the next pattern to be embroidered) with the corner of the reference lines. If the pattern is not angled correctly, rotate it. If the length of the pattern does not match, enlarge or reduce the pattern so that the point of the pattern is at the corner of the reference lines. 3  The next pattern to be embroidered appears. Position each pattern and embroider it according to h the on-screen instructions. You will be prompted to align the starting point, rotate the design, and rehoop the fabric when necessary. For details, refer to "Rehooping the fabric" on page 108. a b c * * Inner corner of next pattern to be embroidered After making adjustments, touch . Note • For the accurate start point, turn the handwheel toward the LCD panel to lower the needle. Check the needle drop point, and then turn the handwheel again until the needle is raised to its highest position. d a a b c c b a 107