Brother International PR1055X Operation Manual - Page 159

MY DESIGN CENTER Memo • If you want to scan an image from a small piece of paper that can't be held with the magnets, copy that image onto a larger piece of paper, and then place it on the scanning frame. Install the needle plate cover included with the d machine. Note • When placing the paper in the scanning frame, make sure that the white balance area is not hidden; otherwise, the drawing cannot be scanned correctly. At the same time, be sure to place the scan image within the scan area. The image out of the scan area will not be scanned. 1 Needle plate cover Align the holes in the scanning frame with the pins on e the frame-mounting plate of the carriage. 4 1 Pins on the frame-mounting plate 2 Holes in the scanning frame Secure the scanning frame with the two thumb screws f removed in step c. 1 White balance area 2 Scan area • Make sure that the white balance area or the scan area is not dirty or scratched; otherwise, the image cannot be scanned correctly. • Use the magnets which are included with the scanning frame. If any other magnets are used, they may become attached to the machine during scanning, or other problems, such as a misaligned scan image, may occur. • Be sure to place the magnets so that they secure the paper firmly. If the paper is placed unevenly, the image cannot be scanned correctly. • If the scanning frame is dirty, wipe it with a cloth dampened with a diluted neutral detergent solution. Remove the two thumb screws securing the c embroidery frame holder, and then remove the frame holder from the machine. 1 Thumb screws ■ Scanning with an embroidery frame Drawings and illustrations can also be scanned using an embroidery frame. Hoop the embroidery frame with fabric larger than the frame. Place the paper to be scanned on the fabric, and then secure it, with tape. 1 Thumb screws 1 Fabric 2 Tape 157