Brother International PR1055X Operation Manual - Page 116

Changing the position of a sticker If the selected pattern or positioning stickers for connecting the next pattern do not easily fit in the embroidering area, follow the on-screen instructions that appear after step m on page 111 in order to move the positioning stickers. For an example, the on-screen instruction appears when you use the embroidery frame with a size of 10 cm × 10 cm (4 inches × 4 inches) to connect patterns as shown below. 1 Pattern A 2 Pattern B Following message appears in step n if the next b pattern or affixed positioning stickers are close to being out of the embroidering area. Follow the instructions and then touch . 1 Refer to steps a through m of"Connecting three a patterns" on page 109 using the embroidery frame with a size of 100 mm × 100 mm (4 inches × 4 inches) to embroider the first pattern and to connect the second pattern. 1 Embroidering area Note • When referring to steps a through m of "Connecting three patterns" on page 109, make sure you select the pattern position to reflect this exercise. 1 Pattern to be embroidered next 2 Embroidery sheet Note • If the message that could not recognize the embroidery positioning sticker appears, rehoop the fabric as indicated in the screen, and then touch . After the positioning stickers have been detected, the c message to inform you that it recognized the embroidery positioning sticker appears. Touch , and then remove the stickers. Affix the two positioning stickers again according to d the on-screen instructions so that the next pattern or positioning marks can fit in the embroidery area. 114  Touch so that the camera detects the first positioning sticker.