Brother International PR1055X Operation Manual - Page 49

BASIC EMBROIDERY Changing the size and the density of the pattern If is selected, you can change the pattern size while maintaining the thread density. The machine recalculates the stitch density automatically. With this function, the pattern can be enlarged or reduced at a larger ratio than with normal pattern resizing. Note • This function cannot be used with character patterns, frame patterns, repeated patterns or large buttonhole patterns. • Patterns with a large number of stitches (100,001 or more) cannot be resized while maintaining a thread density. Memo • Depending on the pattern, the size of the pattern increases up to 200% or reduces to 60%. • You can also change the size by dragging the red point around the pattern. Trimming the threads between characters If the machine is set to trim the threads between the characters, the jump stitches between the characters are reduced and any other necessary procedures after embroidering are reduced. However, the embroidering time will increase if the threads are trimmed between each of the characters. Touch a so that it changes to . 2 • Each touch of the key turns the setting either on or off. Threads are not trimmed. Threads are trimmed. Select or in the size window. a * : Change the pattern size while maintaining the number of stitches. The thread density for the pattern increases or decreases. * : Change the pattern size while maintaining the thread density. After the pattern size is changed, the thread density can be changed. The number of stitches is recalculated depending on the pattern size. When you select b in step a, the message to reset the pattern to its original size, angle and position will appear. Touch . Touch each key to change the pattern size, if desired. c Touch . d Memo • When you select in step a, touch , and then change the thread density. 47