Brother International PR1055X Operation Manual - Page 187
Error messages
View all Brother International PR1055X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 187 highlights
APPENDIX Error messages If the "Start/Stop" button is pressed while the machine is not correctly set up or if an incorrect operation is performed, the machine stops and informs you of the error with a buzzer and an error message. If an error message appears, correct the problem according to the instructions in the message. To close the message, touch or perform the correct operation, then touch your nearest authorized Brother dealer. . If the message appears again, consult Error messages Cause/solution 1 Can not find the positioning mark, please set the This message is displayed when the embroidery positioning sticker cannot frame to the previous position. be found while embroidering a pattern for the optional jumbo frame. Perform the operation again from step h in "EMBROIDERY PATTERNS FOR THE OPTIONAL JUMBO FRAME" on page 140. 2 Cannot change the configuration of the characters. This message is displayed when there are too many characters in the curved text arrangement. Change the text arrangement or the embroidery frame. 3 Cannot communicate between PC and machine. This message is displayed when the machine cannot receive any data from Please check the USB cable connections to run the the computer in the Link mode with the USB cable connection. Turn off the Link application. machine, and check the USB connection. After connect the USB cord securely, turn on the machine again. (page 132) 4 Cannot connect to the PC. Please check the network connection. This message is displayed when the machine cannot receive any data from the computer in the Link mode with the wireless LAN connection. Check the wireless LAN connection between the computer and the machine, and then turn off and on the machine. (page 132) 5 Cannot recognize the data for the selected pattern. This message is displayed when trying to recall damaged pattern data or The data may be corrupted. Please turn off the data created using another manufacturer's data design system. Turn the power and turn on again. machine off, then on again to return it to its normal condition. 6 Cannot recognize the embroidery positioning mark. This message is displayed when the machine fails to recognize the embroidery positioning mark. Confirm that the embroidery positioning mark is in the selected area. If problem persists, reposition the mark. 7 Can't use this key during camera mode. This message is displayed when a key that cannot be used is touched after was touched to enter camera mode. Touch to exit camera mode. 8 Change to a larger embroidery frame. 9 Check upper and bobbin thread. This message is displayed when the thumb screws of the embroidery frame holder are loose. Using the included 3 way screwdriver, firmly tighten the two thumb screws. (page 64) This message is displayed when the installed embroidery frame is too small. Check which embroidery frames can be used, and then install a larger embroidery frame. (page 62) This message is displayed when the thread tension is too tight. Check the tensions of the upper thread and bobbin thread, and then adjust them. (page 116) This message is displayed when the upper thread breaks or the thread comes out of the thread tension disc or a thread guide. Check that the thread passes under the upper and middle thread guides, and correctly thread the upper thread. (page 82) This message is displayed when lint or dust has accumulated in the thread tension disc. Remove the tension dials, and then remove any lint or dust accumulated between the felt washers. (page 176) This message is displayed when the bobbin thread breaks or runs out. Check that there is thread on the bobbin and that approximately 50 mm (2 inches) of thread has been pulled out, and then re-install the bobbin. (page 33) This message is displayed when there may be another cause. Refer to "The upper thread breaks." on page 181 or "The bobbin thread breaks." on page 182. Touch to advance or reverse through the stitching. (page 93) 10 Communication error. When this message is displayed, consult your nearest authorized Brother dealer. 5 185