Brother International PR1055X Operation Manual - Page 121

ADVANCED EMBROIDERY Setting the machine to stop at color changes The machine can be stopped at any time; however, if the machine is stopped while it is embroidering, it is better to go back a few stitches before continuing embroidering to overlap the stitching. If the machine stops at a color change, it is not necessary to go back through the stitching before continuing embroidering. ■ Stopping the machine at the next color change The machine can be set to stop before embroidering the next color. While embroidering the color before the point where a you wish to stop the machine, touch so that it changes to . From the thread color sequence display, select the b thread color where you wish to stop the machine before continuing to embroider.  The selected thread color is highlighted in blue. • If the same thread color is used more than once, they can be combined. After selecting a thread color, touch . The key changes to , and all thread colors in the thread color sequence display that are the same as the one that was selected are highlighted in blue. 3 After finishing embroidering the area for the current b color, the next needle bar moves into position and the machine stops before embroidering the next color.  changes back to . • If the machine is temporarily turned off, you will be asked if you wish to continue embroidering or select a new pattern when the machine is turned on again. Touch to continue embroidering. (page 97) ■ Specifying pause locations before embroidering Pause locations can be specified in the pause setting screen, displayed by touching . Touch a in the embroidering settings screen. Touch . c  The mark appears to indicate where the machine will stop. 1  The pause setting screen appears. 1 mark • To cancel the setting, touch again. Repeat steps b and c for each pause that you wish d to specify. • Any number of pauses can be specified. 119