Brother International PR1055X Operation Manual - Page 139

Touch to select the next section of the pattern, and i then touch . ADVANCED EMBROIDERY INSTALLING THE INCLUDED WIDE TABLE Touch , and then . j Hoop the fabric for the next design section aligning on k the alignment stitching. In this case, align the left side of the hoop on the right side of the design section embroidered in step f. CAUTION • Be sure to install the wide table when using the optional magnetic sash frame, jumbo frame, border frame, quilt frame or flat frame. If these frames are used without the wide table installed, the weight of the frame and fabric may cause the frame to slant and result in poor embroidering quality. 3 Note • When carrying the wide table, be sure to hold it with both hands. • Attach the wide table to the machine before installing the embroidery frame. • Do not place heavy objects on top of the installed wide table or press down on it. • Remove the wide table from the machine while using embroidery frame that do no need to be used with the wide table or while embroidering tubular items, bags or caps. The embroidery frames for these types of objects cannot be installed while the wide table is attached to the machine. Loosen the two thumb screws 5 to 6 turns. a 1 Alignment stitching Note • Make sure that the alignment stitching is completely within the embroidery field. Set the embroidery sheet inside the embroidery frame and align the grid with the alignment stitching for easier placement. Repeat steps g to j to embroider and combine the l remaining sections of the pattern. 137