Brother International PR1055X Operation Manual - Page 80

Memo • The three key panels can be repositioned so that the pattern can easily be viewed. Touch the center of the top of a key panel to view possible locations where the panel can be repositioned. Touch the desired location to move the selected key panel. Using the included embroidery positioning sticker Using the camera built into this machine and the included embroidery positioning stickers, the embroidering position can easily be aligned. Affix an embroidery positioning sticker to the fabric at a the desired embroidering position. Align the center of the large circle in the embroidery positioning sticker with the center of the embroidery pattern. 1 Embroidery positioning sticker 2 Center of embroidery pattern 3 Embroidering area Note • When hooping the fabric in the embroidery frame, make sure that the embroidery pattern will fit within the embroidering area of the frame being used. The possible locations for repositioning the panel appear in gray. 1 Embroidering area 2 Embroidery pattern size 3 Embroidery positioning sticker • Depending on the type of fabric to be used, it may not be possible to easily remove the embroidery positioning sticker. Before affixing the embroidery positioning sticker, check how easily the sticker can be removed by affixing it to a scrap of the same type of fabric. In the embroidering settings screen, touch . b The key panel moves to the selected location. Touch e to return to the previous screen. Note • When using the camera to align the embroidering position on thick fabric, use the thick fabric sensor as described in "Positioning the pattern on thick fabric" on page 74. When the message to revert to original position and c angle appears, touch . 78