Brother International PR1055X Operation Manual - Page 82

 The presser foot is lowered and the embroidery frame moves to show the embroidery area. Touch the arrow keys in the embroidering settings b screen to move the embroidery frame so that the needle drop point is at the center of the area where you wish to embroider. • With a USB mouse, your finger or the touch pen, drag the pattern to move it. Carefully watch the movement of the embroidery frame and check that the embroidery will stitch in the desired location and that the embroidery frame does not hit the presser foot. ■ Temporarily stopping to check the area The embroidery frame can be temporarily stopped at a desired position or the checking of the embroidering area can be stopped. When the embroidery frame moves to the desired a position, touch again.  The embroidery frame stops moving, and the message asking if you want to continue the trial appears. To continue moving the embroidery frame, touch b . To stop checking the embroidering area, touch . • When specifying the starting of stitching, align the needle drop point with the point specified as the starting of stitching. (For details on specifying the starting/ending of stitching, refer to page 126.) ■ Unlocking the needle bar Display the embroidering screen, and then touch the a key for any needle bar other than the one that is locked. ■ Finding the embroidering position By locking the needle bar (securing the needle and presser foot in the down position), the needle drop point can easily be seen. As shown in the illustration, insert the Allen a screwdriver into the hole in the needle clamp to slowly lower the needle bar down till needle bar stops then clicks into the lock position.  The needle bar is unlocked and will return to original position. Note • Make sure that the needle is not lowered beyond the positioning click into the fabric.  The needle and presser foot are locked in the down position. 80