Brother International PR1055X Operation Manual - Page 182
The needle breaks., The thread is not cut automatically., After the threads are automatically cut,
View all Brother International PR1055X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 182 highlights
Symptom Probable Cause/Remedy The needle breaks. The area around the hole in the needle plate is damaged. Page * Symptom Probable Cause/Remedy The hook stopper is not correctly installed, the hook is making a complete rotation. The upper thread is not threaded correctly. The upper thread is catching somewhere. Page * 82 1 Scratches/Burrs • Replace the needle plate. The needle hits/touches the needle plate. 176 * 1 Needle 2 Hole in needle plate 3 Needle hits hole • Replace the needle. The presser foot is set too high and not correctly * positioned. The needle hits/touches the presser foot. The area around the embroidery foot hole is * damaged. 1 Scratches or Burrs • Replace the presser foot. Sliding surface on hook race is not smooth. There * are scratches or burrs on it. 1 Hook race area The bobbin or bobbin case are not correctly installed. The hook is not correctly installed. 33, 35 * • Pull the upper thread by hand from below the presser foot, and check that the thread moves smoothly. If the thread does not move, it is not threaded correctly. Thread the upper thread correctly. Make sure the thread is caught by the needle bar thread guide. The upper thread tension is set too high. 118 A bobbin designed specifically for this machine is 33 not used. The needle and the hook are not correctly * passing each other. • Hook timing may be OFF. There is backlash play (forward/backward) in the * needle bar case. The thread density of the embroidery data is too 190 fine. Three or more overlapping stitches are being embroidered. • Using a data design system, correct the thread density and overstitching settings in the embroidery data. The thread is not cut automatically. Lint or dust has accumulated around the needle 174 plate (moving knife, fixed knife or thread retaining plate). A bobbin case designed specifically for this - machine is not used. • Use the correct bobbin case. Lint or dust has accumulated in the thread 176 tension disc. After the threads are automatically cut, the upper thread is too short and comes out of the needle. Lint or dust has accumulated around the needle 174 plate (moving knife, fixed knife or thread retaining plate). 180