Brother International PR1055X Operation Manual - Page 190

Error messages Cause/solution 52 Stop while needle bar case transferring. This message is displayed when the machine has stopped while the needle bar case is moving. Touch case. to automatically reset the needle bar 53 The pattern combination is too large for the extra large embroidery frame. If you plan to add more patterns, rotate the pattern combination. This message is displayed when a long vertical pattern is recalled and no longer fits in the embroidery frame. Rotate the pattern 90 degrees. 54 The pattern extends out of the pattern area. Change This message is displayed when the built-in camera is being used to align position of the pattern and scan the new area. the embroidery position, but the embroidery positioning sticker is too near an edge or the pattern extends from the embroidery frame. Change the position of the embroidery positioning sticker, and then try aligning the position again. 55 The safety device has been activated. Is the thread This message is displayed when a malfunction occurred, such as the thread tangled? Is the needle bent? becoming tangled or the needle is bent. The machine stops when it detects a malfunction. Check that the machine is correctly threaded (page 82) and that the needle is not bent. 56 This file cannot be used. This message is displayed when the file format is incompatible with this machine. Check the list of compatible file formats. (page 190) 57 This pattern cannot be used since it exceeds the data capacity. This message is displayed when the pattern has too many stitches and cannot be used. Data with stitches that exceed specifications (500,000 stitches) cannot be displayed. Use data design software to reduce the number of stitches. 58 This pattern cannot be used. This message is displayed when you try to retrieve a pattern that was downloaded for a different machine. 59 This pattern cannot combine. This message is displayed when a split (large-size) pattern is selected to be combined with another embroidery pattern. 60 Trimming sensor error. This message is displayed when lint or dust may have accumulated within the moving knife, the fixed knife, the thread retaining plate, and their surrounding areas. Clean them. (page 174) 61 USB media error This message is displayed when USB media cannot be read correctly or when USB media is damaged. Touch and try again. 62 USB media is not loaded. Load USB media. 63 Wiper error 64 X-axis home position error. 65 XY moving error. 66 Y-axis home position error. This message is displayed when you tried to recall or save a pattern while no USB media is loaded. Load USB media. This message is displayed when you try to use incompatible USB media. For a list of compatible USB media, visit " http://s.brother/cpbag/ ". This message is displayed when thread is tangled on the wiper. Remove the tangled thread. This message is displayed when lint or dust may have accumulated within the moving knife, the fixed knife, the thread retaining plate, and their surrounding areas. Clean them. (page 174) This message is displayed when the thread does not pass through the groove in the thread cutter. Pass the thread through the groove securely. When this message is displayed, consult your nearest authorized Brother dealer. When this message is displayed, either replace the embroidery frame with a larger one or return to the pattern editing screen and move the pattern position. When this message is displayed, consult your nearest authorized Brother dealer. 188