Brother International PR1055X Operation Manual - Page 143

Attach the jumbo frame to the machine. d Touch . e ADVANCED EMBROIDERY • The positioning detection area is under the built-in camera. Note • When you change the embroidering position using the jumbo frame, be sure to be aware of the size of the combined pattern. You cannot change the position exceeding the embroidery area. 1 Built-in camera is in this box. 2 Affix the sticker in this area. When the machine's built-in camera has finished i detecting the location of the embroidery positioning sticker, the following message appears. 3 1 Embroidery area Touch , and then press the "Start/Stop" f button to start embroidering the first section of the pattern. After embroidering of the first section of the pattern is g finished, the message to confirm to embroider the next part appears. Touch . An image of the needle location appears in the screen h with the positioning detection area framed by a red line. Affix an embroidery positioning sticker so that it fits within the red line, and then touch . Note • If the built-in camera cannot detect the location of the embroidery positioning sticker, the message that could not recognize the embroidery positioning sticker appears. Touch , and then perform the procedure again starting from step h. Remove the jumbo frame from the machine, turn the j frame around, and then attach it to the machine. Touch , then the machine starts to detect the k location of the embroidery positioning sticker. When the machine's built-in camera has finished l detecting the location of the embroidery positioning sticker, the following message appears. Touch . 1 1 Red line 141