Brother International PR1055X Operation Manual - Page 135

Memo • When the Link function by the USB cable connection is turned on while [Wireless LAN Enable] is set to [ON], the message to set [Wireless LAN Enable] to [OFF] appears. • When the Link function by the wireless LAN connection is turned on while [Wireless LAN Enable] is set to [OFF], the message to set [Wireless LAN Enable] to [ON] appears. Turn off the machine. e ADVANCED EMBROIDERY When the following message appears, touch . i • USB cable connection • Wireless LAN connection 3 Note • When you turn off the machine, wait for about 5 seconds before turning on the machine again. Connect the machine to the computer. f • USB cable connection  A message appears in the machine's LCD while the machine is connecting to computer. When connecting the machine to the computer, use the included USB cord clamps. (page 131) • Wireless LAN connection Note • For details on using the embroidery editing software, refer to the Instruction Manual included with it. For details on the wireless LAN connection, refer to page 29. Turn on the machine. g * This Link dialog box is found in PE-DESIGN NEXT software. • If the following error message appears, the type of embroidery frame installed on the machine is not compatible with the size of the pattern. Replace the embroidery frame with one compatible with the size of the pattern. Using embroidery editing software with the Link h function, such as PE-DESIGN NEXT or later from a computer, send the pattern to the machine in the Link mode. 133