Brother International PR1055X Operation Manual - Page 111

ADVANCED EMBROIDERY USING THE CAMERA TO CONNECT PATTERNS Hoop fabric in the extra-large embroidery frame (360 c mm × 200 mm (14 inches × 7 7/8 inches)), and then attach the frame to the machine. Instead of using thread marks, the camera can be used to connect patterns. An area of 330 mm × 170 mm (13 inches × 6-1/2 inches) can be embroidered when the camera is used to connect patterns. Select the appropriate frame depending on the size of the embroidery. We recommend using the extralarge embroidery frame (360 mm × 200 mm (14 inches × 7-7/8 inches)) when using the camera to connect patterns. Note • When installing the embroidery frame (small) (60 mm × 40 mm (2-3/8 inches × 1-1/2 inches)), cap frames, cylinder frame, sleeve frame, clamp frames, name frame or the round frames, you cannot connect patterns using this function. • Split (large-size) patterns created with PE-DESIGN version 7 or later cannot be used with this function. • You cannot connect patterns using this function while the machine is set to the Link mode. Touch to display the embroidering settings d screen. Touch . • needs to be selected in order to continue connecting patterns. 3 Connecting three patterns Example:  appears at the bottom left side of pattern display area, and then changes to . Memo • A pattern cannot be saved in the machine's memory while patterns are being connected. Touch , then touch and then press e the "Start/Stop" button to embroider the first pattern. 1 Pattern A 2 Pattern B 3 Pattern C Specify the appropriate image settings in advance. a (page 73) • Better scanning results can be achieved with the appropriate settings. Select the first pattern A, and then touch . b After embroidering of the first pattern is finished, the f message to confirm to connect the next pattern appears. Touch . When the following message appears, touch . g 109