Brother International PR1055X Operation Manual - Page 144

Note • If the built-in camera cannot detect the location of the embroidery positioning sticker, the following error message appears. Touch , return the jumbo frame to its previous orientation, and then perform the procedure again starting from step h. USING THE OPTIONAL BOBBIN WINDER When winding the bobbin thread onto a metal bobbin, use the optional bobbin winder. The procedures for using the optional bobbin winder are described below. Remove the embroidery positioning sticker from the m fabric. Precautions For precautions concerning the power supply, refer to page 22. CAUTION • Be sure to place the bobbin winder on a level, stable surface. • Be sure to use the bobbins supplied with this bobbin winder. Touch to select the next section of the pattern to n be embroidered, and then touch . Touch . o Touch , and then press the "Start/Stop" p button to start embroidering the next section of the pattern. Optional bobbin winder and its accessories Check that the following bobbin winder and accessories are included. When the part code is "*", contact your authorized Brother dealer. 1. c Part Name Part Code Bobbin winder b PRBW1 d a 1 Main power switch 2 Bobbin winder shaft 3 Hole for thread guide 4 Hole for spool pin 5 DC input connector 2. e Spool pin XC5949-051 3. Spool cushion XA0679-050 142