Cisco MCS-7825-H3-IPC1 Service Guide - Page 158

Performance Monitoring in RTMT Chapter 5 Cisco Unified Real-Time Monitoring Tool Tracing, PerfMon Counters, and Alerts Table 5-1 Counter Alert Configuration Parameters (continued) Setting Frequency Pane Trigger alert on every poll; trigger up to... Schedule Pane 24-hours daily; start/stop Description Click the radio button that applies. • Trigger alert on every poll-If you want the alert notification to activate on every poll when the threshold is met, click this radio button. For example, if the calls in progress continue to go over or under the threshold, the system does not send another alert notification. When the threshold is normal (between 50 and 100 calls in progress), the system deactivates the alert notification; however, if the threshold goes over or under the threshold value again, the system reactivates alert notification. • Trigger up to...-If you want the alert notification to activate at certain intervals, click this radio button and enter the number of alerts that you want sent and the number of minutes within which you want them sent. Click the radio button that applies: • 24-hours daily-If you want the alert to be triggered 24 hours a day, click this radio button. • Start/Stop-If you want the alert notification activated within a specific time frame, click the radio button and enter a start time and a stop time. If the check box is checked, enter the start and stop times of the daily task. For example, you can configure the counter to be checked every day from 9:00 am to 5:00 pm or from 9:00 pm to 9:00 am. Note If you require an e-mail notifications, check the Enable E-mail box. You can also use data sampling in RTMT. The perfmon counters that display in the RTMT Perfmon Monitoring pane have green dots that represent samples of data over time. You can configure the number of samples to collect and the number of data points to show in the chart. Table 5-2 lists and describes the parameters. Table 5-2 Data Sample Parameters Parameter Absolute Delta Delta Percentage Description Because some counter values are accumulative, choose Absolute to display the data at its current status. Choose Delta to display the difference between the current counter value and the previous counter value. Choose Delta Percentage to display the counter performance changes in percentage. Cisco Unified Communications Manager Managed Services Guide 5-4 OL-22523-01