Cisco MCS-7825-H3-IPC1 Service Guide - Page 383

Chapter 6 Cisco Unified Serviceability Alarms and CiscoLog Messages Error-Level Alarms OL-22523-01 7 InitializationError-An internal error occurred within Cisco Unified CM while processing the device registration. It is recommended to restart the Cisco CallManager service. If this occurs repeatedly, collect SDL/SDI detailed traces with "Enable SIP Keep Alive (REGISTER Refresh) Trace" and "Enable SCCP Keep Alive Trace" under Cisco CallManager services turned on and contact TAC. 8 DeviceInitiatedReset-Indicates that the error was due to device initiated reset. 9 CallManagerReset-Indicates that the error was due to call manager reset. 10 AuthenticationError-The device failed either TLS or SIP digest security authentication. If the device is a SIP phone and is enabled for digest authentication (on the System > Security Profile > Phone Security Profile, check if "Enable Digest Authentication" checkbox is checked), verify the "Digest Credentials" in the End User config page are configured. Also, check the phone config page to see if the phone is associated with the specified end user in the Digest User drop box. If the device is a third-party SIP device, verify the digest credentials configured on the phone match the "Digest Credentials" configured in the End User page. 11 InvalidX509NameInCertificate-Configured "X.509 Subject Name" doesn't match what's in the certificate from the device. Check the Security Profile of the indicated device and verify the "Device Security Mode" is either "Authenticated" or "Encrypted". Verify the "X.509 Subject Name" field has the right content. It should match the Subject Name in the certificate from the peer. 12 InvalidTLSCipher-Unsupported cipher algorithm used by the device; Cisco Unified CM only supports AES_128_SHA cipher algorithm. Recommended action is for the device to regenerate its certificate with the AES_128_SHA cipher algorithm. 13 DirectoryNumberMismatch-Indicates mismatch between the directory number that the SIP device is trying to register with and the directory number configured in the Cisco Unified CM for the SIP device. 14 MalformedRegisterMsg-(SIP only) A SIP REGISTER message could not be processed because of an illegal format. Possible causes include a missing Call-ID header, a missing AoR in the To header, and an expires value too small. Verify the REGISTER message does not suffer from any of these ills. 15 ProtocolMismatch-The protocol of the device (SIP or SCCP) does not match the configured protocol in Cisco Unified CM. Recommended actions: 1. Verify the device is configured with the desired protocol. 2. Verify the firmware load ID on the Device Defaults page is correct and actually exists on the TFTP server 3. If there is a firmware load ID configured on the device page, verify it is correct and exists on the TFTP server (On Cisco Unified OS Administration page, Software Upgrades > TFTP File Management, look for the file name as specified by load ID). 4. Restart the TFTP and Cisco CallManager services. Use the Cisco Unified OS Administration TFTP File Management page to verify the configured firmware loads exist. 16 DeviceNotActive-The device has not been activated. 17 AuthenticatedDeviceAlreadyExists-A device with the same name is already registered. If this occurs repeatedly, collect SDL/SDI detailed traces with "Enable SIP Keep Alive (REGISTER Refresh) Trace" and "Enable SCCP Keep Alive Trace" under Cisco CallManager services turned on and contact TAC. There may be an attempt by unauthorized devices to register. Cisco Unified Communications Manager Managed Services Guide 6-149