Cisco MCS-7825-H3-IPC1 Service Guide - Page 961

Chapter 9 Vendor-Specific Management Information Base Hewlett Packard MIBs Table 9-13 HP Hardware Status Messages, MIBs and OIDs, MIB Object Names and Clearing Values, and Object Responses (continued) Cisco Unified CM Release 6.x MCS-78xx Status MIB and OID Physical Drive1 CPQIDA-MIB 1.3.6.1.4.1.232.3.2.5.1.1.6 System Fan CPQHLTH-MIB 1.3.6.1.4.1.232.6.2.6.4 MIB Object Name and Clearing Value cpqDaPhyDrvStatus Clearing Value = 2 cpqHeThermalSystem FanStatus Clearing Value = 2 Object Response • Rebuilding (7) Indicates that the logical drive is currently doing Automatic Data Recovery. During Automatic Data Recovery, fault tolerance algorithms restore data to the replacement drive. • Wrong Drive (8) Indicates that the wrong physical drive was replaced after a physical drive failure. • Bad Connect (9) Indicates that a physical drive is not responding. • The following values are valid for the physical drive status: • other (1) Indicates that the instrument agent does not recognize the drive. You may need to upgrade your instrument agent and/or driver software. • ok (2) Indicates the drive is functioning properly. • failed (3) Indicates that the drive is no longer operating and should be replaced. • predictiveFailure(4) Indicates that the drive has a predictive failure error and should be replaced. This value will be one of the following: • other(1) Fan status detection is not supported by this system or driver. • ok(2) The fan is operating properly. • degraded(2) A redundant fan is not operating properly. • failed(4) A non-redundant fan is not operating properly. OL-22523-01 Cisco Unified Communications Manager Managed Services Guide 9-21