Cisco MCS-7825-H3-IPC1 Service Guide - Page 838

RFC1213-MIB (MIB-II) Chapter 8 Industry-Standard Management Information Base An estimate of the interface current bandwidth in bits per second. For interfaces which do not vary in bandwidth or for those where no accurate estimation can be made, this object should contain the nominal bandwidth. ::= { ifEntry 5 } ifPhysAddress OBJECT-TYPE SYNTAX PhysAddress ACCESS read-only STATUS mandatory DESCRIPTION The interface address at the protocol layer immediately below the network layer in the protocol stack. For interfaces which do not have such an address (e.g., a serial line), this object should contain an octet string of zero length. ::= { ifEntry 6 } ifAdminStatus OBJECT-TYPE SYNTAX Integer { up(1), ready to pass packets down(2), testing(3) in some test mode } ACCESS read-write STATUS mandatory DESCRIPTION The desired state of the interface. The testing(3) state indicates that no operational packets can be passed. ::= { ifEntry 7 } ifOperStatus OBJECT-TYPE SYNTAX INTEGER { up(1), -- ready to pass packets down(2), testing(3), -- in some test mode unknown(4), dormant(5) } ACCESS read-only STATUS mandatory DESCRIPTION The current operational state of the interface. The testing(3) state indicates that no operational packets can be passed. ::= { ifEntry 8 } ifLastChange OBJECT-TYPE SYNTAX TimeTicks ACCESS read-only STATUS mandatory DESCRIPTION The value of sysUpTime at the time the interface entered its current operational state. If the current state was entered prior to the last re- initialization of the local network management subsystem, then this object contains a zero value. ::= { ifEntry 9 } ifInOctets OBJECT-TYPE 8-34 Cisco Unified Communications Manager Managed Services Guide OL-22523-01