Cisco MCS-7825-H3-IPC1 Service Guide - Page 385

Chapter 6 Cisco Unified Serviceability Alarms and CiscoLog Messages Error-Level Alarms 1 Administrative only-The device has indicated that this IPv4 address is used for administrative communication (web interface) only 2 Signal only-The device has indicated that this IPv4 address is used for control signaling only 3 Administrative and signal-The device has indicated that this IPv4 address is used for administrative communication (web interface) and control signaling Enum Definitions -IPv6AddressAttributes Value 0 1 2 3 Definition Unknown-The device has not indicated what this IPv6 address is used for Administrative only-The device has indicated that this IPv6 address is used for administrative communication (web interface) only Signal only-The device has indicated that this IPv6 address is used for control signaling only Administrative and signal-The device has indicated that this IPv6 address is used for administrative communication (web interface) and control signaling Recommended Action Investigate any network connectivity problems in the system. It's possible that you have reached the maximum number of devices; the Cisco Unified Communications Manager service parameter, Maximum Number of Registered Devices, controls the number of devices allowed in the system. Taking licensing, system hardware and other related concerns into consideration, you could increase the value of the service parameter. Also, refer to the reason code definitions for recommended actions. No action is required if this event was issued as a result of a normal device rehome. EndPointUnregistered An endpoint that has previously registered with Cisco Unified Communications Manager has unregistered. In cases of normal unregistration with reason code 'CallManagerReset', 'CallManagerRestart', 'DeviceInitiatedReset', 'EMLoginLogout', or 'EMCCLoginLogout', the severity of this alarm is lowered to INFORMATIONAL. An endpoint can unregister for many reasons, both intentional, such as manually resetting the device after a configuration change, or unintentional, such as loss of network connectivity. Other causes for this alarm could include a phone being registered to a secondary node and then the primary node come back online, causing the phone to rehome to the primary Cisco Unified CM node or lack of a KeepAlive being returned from the Cisco Unified CM node to which this endpoint was registered. Unregistration also occurs if Cisco Unified CM receives a duplicate registration request for this same device. Cisco Unified Serviceability Alarm Definition Catalog CallManager/CallManager Severity ERROR Routing List SDL SDI Sys Log OL-22523-01 Cisco Unified Communications Manager Managed Services Guide 6-151