Cisco MCS-7825-H3-IPC1 Service Guide - Page 47

Chapter 2 New and Changed Information Cisco Unified Communications Manager, Release 8.5(1) Reason Code AutoRegisterDBConfigTimeout DeviceTypeMismatch AddressingModeMismatch Description (SCCP only) Unified CM timed out during auto-registration of a device. The registration profile of the device did not get inserted into the database in time. The device will automatically attempt to register again. The device type reported by the device does not match the device type configured on the Unified CM. (SCCP only) Cisco Unified CM detected an error related to the addressing mode configured for the device. One of the following errors was detected: • The device is configured to use only IPv4 addressing, but did not specify an IPv4 address. • The device is configured to use only IPv6 addressing, but did not specify an IPv6 address. The following provides the reason codes that are added for EndPointUnregistered alarm: Reason Code NoEntryInDatabase DatabaseConfigurationError DeviceNameUnresolveable MaxDevRegExceeded InitializationError PowerSavePlus CallManagerForcedRestart SourceIPAddrChanged SourcePortChanged RegistrationSequenceError InvalidCapabilities Description Device not configured properly in the Cisco Unified CM database. Device configuration error in the Cisco Unified CM database. The Cisco Unified CM is unable to resolve the device name to an IP Address internally. Maximum number of device registrations have been reached. Indicates that an error occurred when the Cisco Unified CM tries to initialize the device. The device powered off as a result of the Power Save Plus feature that is enabled for this device. When the device powers off, it remains unregistered from Cisco Unified CM until the Phone On Time is defined in the Product Specific Configuration for this device. (SIP Only) The device did not respond to an Apply Config request and as a result, Unified CM sent a restart request to the device. The device may be offline due to a power outage or network problem. Confirm that the device is powered-up and that network connectivity exists between the device and Cisco Unified CM. (SIP Only) The device has been unregistered because the IP address in the Contact header of the REGISTER message has changed. The device will be automatically reregistered. No action is necessary. (SIP Only) The device has been unregistered because the port number in the Contact header of the REGISTER message has changed. The device will be automatically re-registered. No action is necessary. A device requested configuration information from the Unified CM at an unexpected time. The Unified CM no longer had the requested information in memory. (SCCP only) Cisco Unified CM detected an error in the updated media capabilities reported by the device. The device reported the capabilities in one of the StationUpdateCapabilities message variants. OL-22523-01 Cisco Unified Communications Manager Managed Services Guide 2-5