Cisco MCS-7825-H3-IPC1 Service Guide - Page 547

Chapter 6 Cisco Unified Serviceability Alarms and CiscoLog Messages Notice-Level Alarms Recommended Action Informational purposes only; no action is required. MaxCallDurationTimeout An active call was cleared because the amount of time specified in the Maximum Call Duration Timer service parameter had elapsed. If the allowed call duration is too short, you can increase the value. If you do not want a limit on the duration of an active call, you can disable the limit. If the duration is correct but you did not expect a call to ever exceed that duration, check the trace information around the time that this alarm occurred to try to determine if a gateway port had failed to release a call. History Cisco Unified Communications Release 8.0(1) Action • Severity changed from Informational to Notice. • Following parameters added: - Originating Device name(String) - Destination Device name(String) - Call start time(UInt) - Call stop time(UInt) - Calling Party Number(String) - Called Party Number(String) Facility/Sub-Facility CCM_CALLMANAGER-CALLMANAGER Cisco Unified Serviceability Alarm Definition Catalog CallManager/CallManager Severity Notice Parameters Maximum Call Duration (minutes) [UInt] Originating Device name(String) Destination Device name(String) Call start time(UInt) Call stop time(UInt) Calling Party Number(String) Called Party Number(String) OL-22523-01 Cisco Unified Communications Manager Managed Services Guide 6-313