Cisco MCS-7825-H3-IPC1 Service Guide - Page 962

Hewlett Packard MIBs Chapter 9 Vendor-Specific Management Information Base Table 9-13 HP Hardware Status Messages, MIBs and OIDs, MIB Object Names and Clearing Values, and Object Responses (continued) Cisco Unified CM Release 6.x MCS-78xx Status CPU Fan MIB and OID CPQHLTH-MIB 1.3.6.1.4.1.232.6.2.6.5 MIB Object Name and Clearing Value cpqHeThermalCpuFan Status Clearing Value = 2 Object Response This value will be one of the following: • other(1) Fan status detection is not supported by this system or driver. Network Interface Card (NIC) CPQNIC-MIB 1.3.6.1.4.1.232.18.2.3.1.1.13 • ok(2) The fan is operating properly. • degraded(2) A redundant fan is not operating properly. • failed(4) A non-redundant fan is not operating properly. cpqNicIfPhysAdapter State Clearing Value = 2 and 3 The following values are valid- • unknown(1) The instrument agent was not able to determine the status of the adapter. The instrument agent may need to be upgraded. • ok(2) The physical adapter is operating properly. • generalFailure(3) The physical adapter has failed. Thermal CPQHLTH-MIB 1.3.6.1.4.1.232.6.2.6.1 • linkFailure(4) The physical adapter has lost link. Check the cable connections to this adapter. cpqHeThermalCondition This value will be one of the following: Clearing Value = 2 • other(1) Temperature could not be determined. • ok(2) The temperature sensor is within normal operating range. • degraded(3) The temperature sensor is outside of normal operating range. • failed(4) The temperature sensor detects a condition that could permanently damage the system. Note The system automatically shuts down if the failed (4) condition occurs, so it is unlikely that 4 will ever be returned by the agent. If the cpqHeThermalDegradedAction is set to shut down (3), the system will shut down if the condition occurs. 9-22 Cisco Unified Communications Manager Managed Services Guide OL-22523-01