Cisco MCS-7825-H3-IPC1 Service Guide - Page 657

Chapter 7 Cisco Management Information Base CISCO-CCM-MIB OL-22523-01 deviceNameUnresolveable: The Cisco Unified CM is unable to resolve the device name to an IP Address internally maxDevRegExceeded: Maximum number of device registrations have been reached connectivityError: Cisco Unified CM is unable to establish communication with the device during registration initializationError: Indicates an error occurred when the Cisco Unified CM tries to initialize the device deviceInitiatedReset: Indicates that the error was due to device initiated reset callManagerReset: Indicates that the error was due to Cisco Unified CM reset authenticationError: Indicates mismatch between configured authentication mode and the authentication mode that the device is using to connect to the Cisco Unified CM invalidX509NameInCertificate: Indicates mismatch between the peer X.509 certificate subject name and what is configured for the device invalidTLSCipher: Indicates Cipher mismatch during TLS handshake process directoryNumberMismatch: Indicates mismatch between the directory number that the SIP device is trying to register with and the directory number configured in the Cisco Unified CM for the SIP device malformedRegisterMsg: Indicates that SIP device attempted to register with Cisco Unified CM, but the REGISTER message contained formatting errors protocolMismatch: The protocol of the device (SIP or SCCP) does not match the configured protocol in Cisco Unified CM deviceNotActive: The device has not been activated authenticatedDeviceAlreadyExists: A device with the same name is already registered with Cisco Unified CM obsoleteProtocolVersion: The SCCP device registered with an obsolete protocol version databaseTimeout: Cisco Unified CM requested device configuration data from the database but did not receive a response within 10 minutes registrationSequenceError: (SCCP only) A device requested configuration information from the Cisco Unified CM at an unexpected time. The Cisco Unified CM had not yet obtained the requested information. The device will automatically attempt to register again. If this alarm occurs again, manually reset the device. If this alarm continues to occur after the manual reset, there may be an internal firmware error invalidCapabilities: (SCCP only) The Cisco Unified CM detected an error in the media capabilities reported in the StationCapabilitiesRes message by the device during registration. The device will automatically attempt to register again. If this alarm occurs again, manually reset the device. If this alarm continues to occur after the manual reset, there may be a protocol error capabilityResponseTimeout: (SCCP only) The Cisco Unified CM timed out while waiting for the device to respond to a request to report its media capabilities. Possible causes include device power outage, network power outage, network configuration error, network delay, packet drops, and packet corruption. It is also possible to get this error if the Cisco Unified CM node is experiencing high CPU usage. Verify that the device is powered up and operating. Verify that network connectivity exists between the device and Cisco Unified CM, and verify that the CPU utilization is in the safe range securityMismatch: The Cisco Unified CM detected a mismatch in the security settings of the device and/or the Cisco Unified CM. The mismatches that can be detected are: Cisco Unified Communications Manager Managed Services Guide 7-15