Cisco MCS-7825-H3-IPC1 Service Guide - Page 465

Chapter 6 Cisco Unified Serviceability Alarms and CiscoLog Messages Warning-Level Alarms Enum Definitions for IPV6AddrAttributes Code 0 1 2 3 Reason Unknown - The device has not indicated what this IPv6 address is used for Administrative only - The device has indicated that this IPv6 address is used for administrative communication (web interface) only. Signal only - The device has indicated that this IPv6 address is used for control signaling only. Administrative and signal - The device has indicated that this IPv6 address is used for administrative communication (web interface) and control signaling. Recommended Action Actions to take vary depending on the reason specified for the device unregistration. If the reason is ConfigurationMismatch, go to the Device Configuration page in Cisco Unified CM Administration, make a change to the Description field for this device, click Save, then reset the device. In the case of a network connectivity or loss of KeepAlives problem, use network diagnostic tools and the Cisco Unified CM Reporting tool to fix any reported network or Unified CM system errors. In the case of a device rehoming to the primary Unified CM node, watch for a successful registration of the device on the primary node. In the case of a duplicate registration request, it may be a non-malicious occurrence due to timing of a device registering and unregistering; if duplicate registration requests continue or if the same device has different IP addresses, confirm the IP address on the physical device itself by checking the settings on the device (settings button). If unregistration of this device was expected, no action is required. Also, refer to the reason code descriptions for recommended actions. DigitAnalysisTimeoutAwaitingResponse Cisco Unified Communications Manager sent a routing request to the policy decision point but the request timed out without a response. Cisco Unified Communications Manager (Unified CM) was unable to complete the routing request before timing out. This time out could occur due to low system resources, high CPU usage, or a high volume of call activities on this Unified CM node. Unified CM applies the Call Treatment on Failure that is configured for the External Call Control Profile associated with this call. Cisco Unified Serviceability Alarm Definition Catalog CallManager/CallManager Severity WARNING Routing List SDL SDI Sys Log Event Log OL-22523-01 Cisco Unified Communications Manager Managed Services Guide 6-231