Cisco MCS-7825-H3-IPC1 Service Guide - Page 417

Chapter 6 Cisco Unified Serviceability Alarms and CiscoLog Messages Error-Level Alarms Event Log Data Collector Parameters IP Address(String) SafClientHandle(UInt) Application User Name(String) Reason Code and Description(Enum) SAF Protocol Version Number(String) Service ID(UInt) Sub Service ID(UInt) Recommended Action Refer to the reason code and description (help text) for specific information and actions (where applicable) for this alarm. Enum Definitions - Reason Code Value 400 431 435 436 438 Definition SAF_BAD_REQUEST - SAF Forwarder was unable to accept the request due to incorrect syntax (malformed), missing required attributes, and other similar reasons. Investigate the configuration between the SAF Forwarder and Unified CM to be certain that all settings are correct for your deployment. In particular, check the Client Label configured on the router to make certain that it matches the Client Label configured in Cisco Unified CM Administration on the SAF Forwarder Configuration window (SAF > SAF Forwarder). SAF_INTEGRITY_CHECK_FAILURE - A message failed to pass SAF Forwarder security validation. This can occur because of misconfiguration, a potential attack, or more commonly by incorrect provisioning of the password on the Forwarder and SAF client. Reprovision the password and keep a watch on further SAF INTEGRITY CHECK FAILURE alarms. If you receive a persistent number of SAF INTEGRITY CHECK FAILURE alarms, close the interface between SAF Forwarder and Unified CM and investigate the source of the IP packets. **INFO LEVEL** SAF_MISSING_NONCE - A nonce (a random parameter generated when the message is sent) is missing from the message. The system will resend with a new nonce automatically. No action is required. SAF_UNKNOWN_USERNAME - Unified CM sent the SAF Forwarder an Application User name that is not configured on the router or that does not match the router's configuration. Check the Application User Name on the router and in the Application User Configuration window in Cisco Unified CM Administration to be sure they match. **INFO LEVEL** SAF_STALE_NONCE - A nonce (a random parameter generated when the message is sent) has aged out (gone stale). The system will resend with a new nonce automatically. No action is required. OL-22523-01 Cisco Unified Communications Manager Managed Services Guide 6-183