Dell 2335dn Dell™ 2335dn MFP User's Guide - Page 162

Redial Delay Redial Attempt MSG Confirm Auto Report Auto Reduction Discard Size Receive Code accessing Fax On Hook Dial Yes when the bell is ringing (you can hear voice or fax tones from the remote machine) and then pressing Start ( operator panel. ) on the Ans/Fax mode : The printer can share one telephone line with an answering machine. In this mode, the printer may monitor the fax signal and pick up the line if there are fax tones. If the phone communication in your country is serial, this mode is not available. DRPD mode : Before using the Distinctive Ring Pattern Detection (DRPD) option, distinctive ring service must be installed on your telephone line by the telephone company. After the telephone company has provided a separate number for faxing with a distinctive ring pattern, configure the fax setup to monitor for that specific ring pattern. Your printer can automatically redial a remote fax machine if it was busy . Intervals from 1-15 minutes can be entered. You can specify the number of redial attempts, 0-13. You can set your printer to print a report showing whether the transmission was successful, how many pages were sent, and more. The available options are On , Off and On-Error , which prints only when a transmission is not successful. A report with detailed information about the previous 50 communications operations, including time and date. The available options are On or Off . When receiving a document as long as or longer than the paper loaded in the paper tray, the printer can reduce the size of the document to fit the size of paper loaded in the printer. Select On if you want to automatically reduce the incoming document . With this feature set to Off , the printer cannot reduce the document to fit onto one page. The document is divided and printed in actual size on two or more pages. When receiving a document as long as or longer than the paper installed in your printer, you can set the printer to discard any excess at the bottom of the page. If the received page is outside the margin you set, it will print on two sheets of paper at the actual size. When the document is within the margin and the Auto Reduction feature is turned on, the printer reduces the document to fit it onto the appropriate sized paper and discarding does not occur. If the Auto Reduction feature is turned off or fails, the data within the margin will be discarded. Settings range from 0-30 mm. The Receive Code enables you to initiate fax reception from an extension phone plugged into the extension telephone socket( ) on the back of the printer. If you pick up the extension phone and hear fax tones, enter the Receive Code. The Receive Code is preset to *9 * at the factory. Settings range from 0-9. See "Receiving Manually Using an Extension Telephone" for more information about using the code.