Dell PowerConnect W-IAP92 Dell Instant 6.1.3.4-3.1.0.0 User Guide - Page 185

2. Select the Uplink tab. Under 3G/4G tab, enter the parameters: a. Enter the type of the 3G/4G modem driver type:  To provision 3G modem, enter the type of 3G modem in the USB type text box.  To provision 4G modem, enter the type of 4G modem in the 4G USB type text box. NOTE: This release of Instant supports only the Pantech UML 290 4G card and is a True Auto Detect modem. b. Enter the identifier of the modem device in the USB dev text box. c. Enter the TTY port of the modem in the USB tty text box. d. Enter the parameter to initialize the modem in the USB init text box. e. Enter the parameter to dial the cell tower in the USB dial text box. f. Enter the username used to dial the ISP in the USB user text box. g. Enter the password used to dial the ISP in the USB password text box. h. Enter the parameter used to switch modem from storage mode to modem mode in the USB switch mode text box. NOTE: The parameter details are available from the manufacturer of your modem or from your IT administrator. Figure 155 Provisioning 3G/4G Uplink- Manually NOTE: You must reboot the IAP after manually provisioning the IAP. Provisioning 3G Uplink Automatically In automatically provisioning 3G uplink, the user has to provide inputs for country and ISP in the Country and ISP textboxes. The IAP finds the parameters internally. Figure 156 Provisioning 3G Uplink- Automatically NOTE: In Instant UI, if the user can view the list of country or ISP in the country and ISP drop-down lists, the user can either use the country or ISP to configure the modem, or configure the individual modem parameters manually. If the user cannot view the list of country or ISP from the drop-down list, then the user has to configure the modem parameters manually. Dell PowerConnect W-Series Instant Access Point 6.1.3.4-3.1.0.0 | User Guide Uplink Configuration | 185