Dell PowerConnect W-IAP92 Dell Instant 6.1.3.4-3.1.0.0 User Guide - Page 82
Configuring Uplink Management VLAN, Configuring Wired Bridging on Ethernet 0, Edit AP, Radio
View all Dell PowerConnect W-IAP92 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 82 highlights
2. Click the edit link. An Edit AP window appears. 3. In the Edit AP window, select the Radio tab. 4. Select Adaptive radio management assigned. Figure 68 Configuring IAP Radio Settings Mode - Access 5. Click OK. For more information about ARM, see "Adaptive Radio Management" on page 159. Configuring Uplink Management VLAN Instant supports a management VLAN for the uplink traffic on an IAP. After an IAP is provisioned with this parameter, all management traffic sent from the IAP is tagged with the management VLAN. Perform the following steps to configure a uplink management VLAN on an IAP: 1. In the Access Points tab, click the IAP. 2. Click the edit link. An Edit AP window appears. 3. In the Edit AP window, select the Uplink tab. 4. Specify the VLAN in the Uplink Management VLAN field. 5. Click OK. NOTE: This configuration requires an IAP reboot to take effect. Configuring Wired Bridging on Ethernet 0 Instant supports wired bridging on the Ethernet 0 port of an Instant AP. Perform the following steps to enable wired bridging on the Ethernet 0 port: 1. In the Access Points tab, click the IAP. 2. Click the edit link. An Edit AP window appears. 3. In the Edit AP window, select the Uplink tab. 4. Select Enable from the Eth0 Bridging drop box. 5. Click OK. 82 | Managing IAPs Dell PowerConnect W-Series Instant Access Point 6.1.3.4-3.1.0.0 | User Guide